คลิกที่รูปภาพเพิ่มเติมจะมีรูปเพิ่ม

Features:

★  This module uses ST's L298N chip as the main driver, with driving ability, low heat, strong anti-interference ability characteristics.

★  This module can use the built-in 78M05 to take power through the drive power part of the work, but in order to avoid damage to the regulator chip, when the driving voltage is greater than 12V, please use an external 5V logic supply.

★  This module uses high-capacity filter capacitors, freewheeling diode protection, reliability can be improved.

★  This module finished with the goods, please directly photographed can, thank you.

L298N motor driver board stepper motor module Smart Car Robot Arduino

NOTES:

1. When you drive voltage ( 12V input labeled on the map, you can accept the actual input range is 7-12V ) to 7V 
-12V, you can enable the onboard 5V logic supply, when using the onboard 5V power supply after The interface of the + 5V 
power supply input voltage do not, but can lead to 5V voltage for external use. (This is the conventional application!)

2. When the drive voltage higher than 12V, less 24V (chip manual proposes support to 35V, but in accordance with an 
application when the experience is generally a conservative 298 to 24V maximum voltage support has been very great!), for example, to drive a rated voltage of 
18V, motor. First, you must unplug the onboard 5V output enable jumper caps. Then external access 5V 5V output port

5V Enable namely